When senpai needs a napkin but you're not giving it cause you love him or anything
Getting there, oh glob I can't wait till it's calibrated perfectly so I can print up stuff
Made good progress today on this. Can't wait to start using it to make parts for my pharah!!!!! #prusai3mk3
About to step up my cosplay nonsense
So apparently ikea sells light strips
Smoothed down edges check, carved designs with a wood burning pen check, tape off areas that don't need plasti dip check, and now to seal
Decided to cut up my failed armor piece where the vinyl may overlap. That did help to solve some of the issues from the first piece. You can use a heat gun tho on the lowest setting.
The indent of the armor I cut out and roughly sketch it out on the back of the vinyl. I tried just attaching the vinyl that has an adhesive back, but wasn't sticky enough so I had to add a layer of cc.
For simple pieces like this it looks like it wouldn't be "too" difficult. If you take your time and plan it out. Im hoping my preparations and practice runs will work out for the cosplay I want to use this on
Experimenting with vinyl with some failed foam pieces. Definitely benefits from it and can see about it saving time. I need to figure out how to avoid that messed up area
Since im adding extra "features" to the jet pack I have to make a lot of custom pieces. Im glad I didn't try to con crunch this. Sometimes it is better to work slow and get it right then rush and make some mistakes which could of been resolved.
#cosplay #overwatchcosplay #pharah